#White led flood lights full#

Wait 30 seconds to a minute, and then turn it on.

It is helpful to color the end with a dot using a Sharpie marker.) Then TURN OFF the electricity or wall switch. Turn the rounded end of the raised stick on the knob all the way to the left to test. If it has not, it will not work properly when you set your settings. This is a must in order to fully activate the sensors. Why doesn't it turn off or light erratically?You need to reboot the microprocessor in the sensor.

#White led flood lights full#

It takes a full day or two for the adjustments to re-calibrate to the newest setting.SE1097-WH3, BP2-02LF0-G SE1095-WH3, -BP2-LF0-G*First thing to check is if it came on twice in test mode. It will come on during this time, but may not trigger every time that you think it should.

So wait 24-28 hours after the settings have been set or reset. It takes custom readings every 2-3 minutes during the Learning mode. It sees motion through temperature fluctuations. Why?įor best test results, the the fixture needs to acclimate to the outside temperature for about 1 hour before putting it into test mode.Why? The sensor is a PIR (Passive Infa Red) sensor. Problems with settings, on all night, timer, motion sensor. Perform a “walk by test” by walking across the motion detection field at the approximate distance set on the DISTANCE control knob. The reverse is true when the DISTANCE control knob is turned to “MAX.” it increases the detection zone exponentially. When the DISTANCE control knob is turned to “10 Ft”, the detection zone is very tight and compact, causing the detection sensitivity to be very high. Rotate the DISTANCE control knob anywhere from “10 Ft” to MAX (100 ft). Do not rotate the MINUTES control knob back to the TEST area, or to switch control. Rotate the MINUTES control knob away from the MOTION TEST and set between the 1 and 10. Once out of the detection range, the light will shut off and the test is complete. Resume walking and the light should turn on. Remain still for approximately 5 seconds (when movement is no longer detected), the light will shut off. As movement is detected, the light will activate. With the control knob set to MOTION TEST, do a “Walk by Test” by walking in front of the motion sensor (figure at right). The light will turn on for approximately 20 seconds. Allow the motion sensor about 2 minutes to warm up prior toconducting the “walk by test.” Rotate the MINUTES control knob to MOTION TEST to calibrate the fixture. Light operates day or night at switch control setting. Light only operates after dark with Motion Setting. Motion- or switch-controlled settings.Distance control options 10, 20, 50, and 100 feet.Time control setting options are available from test, 1 minute, 5 minute, and 10 minutes to set how long the light will stay on after motion is no longer detected.180-degree adjustable passive infrared (PIR) sensor detects motion up to 100 feet away.Wall- or eave-mounted for greater flexibility.IP65 rated water- and dust-proof - ideal for outdoors wet locations with sturdy die cast aluminum construction, shatter-resistant lens, and cold weather rated with a minimum cold start temperature of negative 20☏.Selectable color temperature settings choose from warm white (3000K), bright white (4000K), or daylight (5000K).Selectable brightness level 7000 or 2000 lumens.Light your Backyard or Business like a StadiumTM with minimum light coverage of 86 feet outward and 92 feet wide - perfect for illuminating large areas at night.